How to use the Indoor HD camera with a Panasonic Home Network System using the Panasonic Home Network App.

Do not perform this procedure if you are using the camera by itself (i.e., you do not have a KX-HNB600 hub). In such case use the HomeHawk App.

If you want to integrate your HD camera with a Home Network System, you must register the camera to the hub.

Confirm the following before you begin.

• Make sure you can use your mobile device to connect to the hub
• Make sure the hub’s firmware is up to date and that you are using the latest version of the [Home Network] app.

1. Plug in the camera and wait about 1 minute for the camera’s LED to light in green. If the LED does not light in green, or if you experience trouble during this procedure, use the camera’s reset button to reset the camera (Using the camera’s reset button) and then repeat this procedure.
2. Start the [Home Network] app.
3. From the [Home Network] app home screen, tap [Settings].
4. Then tap [Device Registration].
5. Tap [Registration],
6. Tap [HD Camera]
7. Tap [Method 1].
8. When prompted, press the SETUP button on the back of the camera. The camera registers your mobile device. The app’s home screen is displayed when registration is complete.
9. Continue to follow the on-screen instructions. When prompted, set the password that will be used to connect to the camera.

Note

• When registration is complete, the hub sounds one long beep.
• If registration fails, the hub sounds several short beeps.