- The " Jet of Steam" feature provides extra steam which goes
deep into the garment and is helpful for removing stubborn
wrinkles.
- The " Jet of Steam" feature operates properly only in the
[ Linen ] position of the Temperature Selector dial when
steam or dry ironing (If used at lower setting, water spotting
will occur because the iron is not hot enough to change water
to steam).
- If you have not used the " Jet of Steam" feature for a long
time, it is necessary to clean the inside of the iron before
using this feature on any clothes to be ironed.
- Simply test the " Jet of Steam" feature several times away
from the ironing board and clothes to be ironed. This will
prevent brown spotting or water spotting on clothes.
- Fill the iron with water (refer
to How to fill water).
- Position the iron vertically and be sure the Temperature
Selector is set to [ Off ].
- Plug the main lead into the household socket.
- Set the Temperature Selector dial to the [ Linen
] position.
- Preheat the iron until the Indicator light goes out,
usually takes about 1- 2 minutes.
- Simple pump the [ Jet of Steam ] button when steam is
desired. Pump the [ Jet of Steam ] button several times at the
beginning of each ironing session.
- Allow at least 2 - 5 seconds between uses of the [ Jet
of Steam ] to prevent water spotting. Use a press cloth if
necessary.
Do not use the "Jet of Steam" button until
the Thermostat Opertaing Indicator Light turns off after the
Temperature Setting Dial to "Linen". Hot water may leak
from the Soleplate and burns may result, and it may cause
corrosion.
Do not touch the fabric with the iron. Keep the iron
slightly over the fabric to prevent burns or disfiguring.
Vertical Steam
Perform the steps above.
Vertical Steam tips
-
Hang your garment on a hanger, and then attach the
hanger to a hanger hook. Curtains and drapes may also
be steamed once they are hung.
- Hold the iron away from your body, close to but not
touching the fabric.
- Pull the garment tight with your free hand and
pump the [ Vertical Steam ] (Jet of Steam) button
at 2-5 second intervals as you pass the iron over the
wrinkled fabric.