How to clean the facial cleansing device. - EH-XC10

Rinse foam off the brush with water and then remove.
Open the facial cleanser compartment cover, begin pouring water into the foam dispenser, and then press the facial cleanse switch to rinse.
- If a significant amount of facial cleanser remains, the power may turn off a few seconds after pressing the facial cleanse switch or it may not operate smoothly. In such cases, use warm water to clean and remove the excess cleanser.
Press the facial cleanse switch to turn off the power.
Manually clean the brushes, warming makeup removal plate, and around the facial cleanser compartment.
Clean the facial cleanser compartment thoroughly as facial cleanser tends to accumulate in this area.
- If you become concerned about dirt accumulating in the brush, apply facial cleanser to the brush and wash it by hand.
- Please note that the bristle portion of the silicone brush may come off if pulled strongly.
- Please reattach the silicone part if it becomes detached.
Shake the main body to remove excess water.
Lightly wipe with a towel or similar and place on the stand to dry.
- Leave the facial cleanser compartment cover open to dry.
- Place the brush and measuring cap at the rear of the stand.
- After cleaning, store in a location with low humidity. (Storing the appliance in an enclosed shower or bath may cause condensation and rust to develop inside the main body leading to failure.)