How to adjust the Tonearm height - Technics model SL-1000R

Adjusting the Tone Arm Height

Note: Make this adjustment only if the cartridge you are using makes it necessary.

Preparation

• Place a record on the turntable.
• Release the arm lock.
  

Adjustment Steps

1. Turn the arm-height control ring:
   • Align the position mark with the index line 1 on the control ring 2.
   • The control ring is marked from 0 to 15 mm.
     


2. Adjust the height:
   • Use the arm-height control ring to adjust the arm height until the tone arm becomes parallel to the record.
     
   • Remove the stylus cover carefully to avoid damaging the stylus, then release the arm clamp.
   • Lower the cue lever and rest the stylus on the record. Adjust the height control until the tone arm and record are parallel.


3. Lock the tone arm:
   • After adjustment, secure the tone arm by turning the arm lock knob.
   • Ensure you turn the arm lock knob fully, as shown in the figure below. Some force may be needed.

Attention

• Handle the stylus tip with care to avoid damage.
• Do not use the product with the arm lock released.
• For finer adjustment, use a level (not included) to ensure the cartridge is parallel to the record.